Preface Thickness Scaling of Forming Limit Curves Work Hardening of Dual Phase Steel in Subsequent Tensile Testing with Post-Necking Large Pre-Strain Crystal Plasticity Finite-Element Simulations of Cup Drawing of a ZX10 Magnesium Alloy Sheet In Situ EBSD Characterisation of Anisotropic Creep Behaviour in a Thick AA2139 Part during In-Forming Artificial Ageing Microstructural Modification and Bendability Improvement in 1300 MPa Steel via Induction Surface Heat Treatment The Interaction of n- and r-Values and Total Elongation in Forming Limit Curves' Theories Theoretical and Experimental Forming Limit Evaluation of High-Strength Steels up to 1500 MPa Evaluation and Comparison of a few Methods for the Strain-Path Correction of FLCs Investigating the Formability of Aluminium Alloy Tubes by Rubber Bulge Testing Influence of Hydrogen Content on the Ductile Rupture of Advanced High-Strength Steels Asymmetric Hole Expansion Test (aHET) for Direct Measurement of Orientation-Dependent Tensile Fracture Strain A Comparative Study of Multiple Cutting Methods on Thin Ferritic Steel for Tensile Test Experiment Effect of Tool Edge Geometry on Sheared Surface Formation in Blanking of Oxygen-Free Copper Experimental Investigation of the Influence of Load Direction Changes on Damage in Dual Phase Steel and Aluminum Alloy Stochastic Forming Limit Curves: Construction of a Probabilistic Tool for Failure Assessment Forming Limit Test of Asymmetric Al-Polymer Laminate Composite Film Hole Expansion Performance Assessment of Quenched and Partitioning Steel through a Fully Anisotropic Fracture Modeling Global and Local Formability of 3rd Generation Advanced High Strength Steels Formability Test for Characterizing the Mode II-III Fracture Transition Assessing Global and Local Formability from Tensile Tests with Anisotropy Consideration The Influence of Uphill Quench on the Microstructure and Properties of Particle-Reinforced Aluminum Matrix Composites Automated Testing and Calibration of Sheet Metal Models Springback Prediction of 6XXX-Series Aluminum: Effect of Hardening Model, Friction and Binder Loading Necking Limits of Anisotropic Metal Sheets Using M-K Theory and Improved Plasticity Models Effect of Continuous Bending under Tension on Dual-Phase Steels Heterostructure High Entropy Alloys in the CoNiFeMn-Mo System Intended for Deep Drawing Applications.